DTF Capping Station
The part that decides whether the head survives the night
The capping station seals the printhead when the machine is idle and draws ink through during cleaning. A worn cap lets ink dry in the nozzles, which is one of the most common causes of a printhead that needs replacing.
What the capping station does
The cap sits against the nozzle plate and keeps it moist. During cleaning it seals and draws ink, clearing clogs. If the cap is worn, ink dries on the plate overnight and the morning nozzle check fails.
- Seals the head during idle
- Draws ink during cleaning cycles
- Wears with ink and cleaning solution
- Replace when the nozzle check degrades
Maintenance and replacement
Inspect the cap weekly, clean ink residue, and replace it when the seal no longer holds or cleaning cycles stop recovering nozzles. Keep a spare on the shelf; it is cheaper than a printhead.
When replacing, check the damper and ink lines at the same time. A worn ink-supply part can mimic a capping fault by starving the head during cleaning.
Capping and ink-supply parts listed
The catalogue lists the XP600 Capping Station at US$3.60–4.20, and the I3200 Ink Supply Part at US$1.56–2.16,, with a 3–5 working day parts lead time.
Confirm the printer model and head configuration before ordering. The capping station is matched to the head and carriage, not just the film width.
Products
FAQ
How often should a DTF capping station be replaced?
Inspect weekly and replace when the seal no longer holds or cleaning stops recovering nozzles. Under daily production, many shops replace it every few months.
What happens if I run without a working capping station?
The printhead dries out, nozzles clog and the head may need replacing. The capping station is the cheapest part in that chain.
How much is a replacement capping station?
The XP600 Capping Station is listed at US$3.60–4.20; the I3200 Ink Supply Part is listed at US$1.56–2.16. Confirm the model before ordering.
Does the capping station fit both A1 and A3 printers?
It is matched to the head and carriage, not the film width. Send the printer model and head configuration and the correct part will be confirmed.
Not sure which machine?
Tell us what you print and how much per day. We will recommend a width, head count and printhead — and tell you where the next size up stops paying for itself.
Talk to Technical Sales


